Tuff Coat Rubberized Deck Coating UT-100-Cblue RCW7S_AL391

Product details:

Tuff Coat Rubberized Non-Skid Marine Deck Coating - Gallon - Tuff Coat is a high-performance, non-skid polyurethane safety coating that works to effectively coat and weatherproof a number of surfaces. This UV resistant coating protects your boating surfaces, and employs a non-abrasive, crumb aggregate texture that can be sprayed or brushed on, according to how much texture you desire for a protected, non-skid surface. Tuff Coat is highly effective in absorbing noise, which makes it extremely handy in coating aluminum boats and skiffs, as well as lessening the noise in your truck, dock, deck, or ramp. One quart covers approximately 12 sq. ft.; 1 gallon covers about 40-45 sq. ft. - Water-Based & Eco Friendly - Recycled High-Grip Rubber Granules - UV & Chemical Resistant - Single Component - No Mixing - Simple Do-it-Yourself Application - Features & Benefits: Coverage - 1 Gallon of Tuff Coat covers approximately 40-45 square feet Surfaces covered with Tuff Coat Rubberized Coatings must be primed with Tuff Coat Primer (See note below) Helps prevent slips Deadens and absorbs noise Texture may be varied when applied Non-toxic and environmentally friendly(no VOC's) Consists of recycled rubber crumb aggregate-non abrasive UV resistant pigments & stabilizers enhance protection Protects against chemicals such as acids, solvents, fuels, chlorine, salts, etc. Resists impact Waterproofs wood decking Can be sprayed, brushed or roller applied, easy for the beginner Dries to a quick, easy to clean finish - Application Specs: Temp: 40F min. - 120F max. (air, surface, & material) Relative Humidity: 85% maxiumum Method: Roll TUFF-Coat Rollers Spray Superior Hopper Gun or Texture Sprayer Finish: Matte finish Appearance: Textured colored liquid Recommended Spread Rate: Wet mils: 50-60 Dry mils: 35-40 Coverage: 40-45 Sq. Ft. in 2 coats - Drying Schedule (20 mils wet @50% RH, 72o - F) To touch: Approx. 1 hour To top coat: Approx. 1-2 hours To cure: Approx. 24hrs-5 days for full chemical cure - How to Apply Tuff Coat Rubberized Deck Coating Application Method: Roller, Spray Application Temperature: 40F or higher Coats: 2 Light Traffic | 3 Heavy Traffic - Prior to applying Tuff Coat, stir thoroughly before applying and stir periodically to maintain aggregate in suspension. Dilute the product with clean water only. A dilution of 10% will reduce the solids within the product by the same amount. In order to avoid "cracking" do not allow Tuff Coat Rubberized Deck Coating to pool and do not apply coats too thick during the application. - Note: It is recommended that you preform a test patch to ensure adhesion before applying fully. - Surface Preparation - Concrete Must be fully cured. If concrete surface has a porous texture, no further surface preparation is necessary. If the concrete surface is not porous, then acid etching, sanding or shot blasting is necessary. Make sure to use a light acid etch and to remove all remaining acid with soap and water and scrub brush. Concret